Adafruit Feather M0

The Adafruit Feather M0 is a tiny ARM development board based on the Atmel ATSAMD21G18 family of SoC.

Interfaces

Interface Hardware Supported TinyGo Support
GPIO YES YES
UART YES YES
SPI YES YES
I2C YES YES
ADC YES YES
PWM YES YES
USBDevice YES YES

Pins

Pin Hardware pin Alternative names PWM
D0 PA11 TCC1 (channel 1), TCC0 (channel 3)
D1 PA10 I2S_SCK_PIN TCC1 (channel 0), TCC0 (channel 2)
D3 PA09 TCC0 (channel 1), TCC1 (channel 3)
D4 PA08 I2S_SD_PIN TCC0 (channel 0), TCC1 (channel 2)
D5 PA15 TCC0 (channel 1)
D6 PA20 TCC0 (channel 2)
D8 PA06 TCC1 (channel 0)
D9 PA07 TCC1 (channel 1)
D10 PA18 UART_TX_PIN TCC0 (channel 2)
D11 PA16 UART_RX_PIN TCC2 (channel 0), TCC0 (channel 2)
D12 PA19 TCC0 (channel 3)
D13 PA17 LED TCC2 (channel 1), TCC0 (channel 3)
A0 PA02
A1 PB08
A2 PB09
A3 PA04 TCC0 (channel 0)
A4 PA05 TCC0 (channel 1)
A5 PB02
USBCDC_DM_PIN PA24 TCC1 (channel 2)
USBCDC_DP_PIN PA25 TCC1 (channel 3)
SDA_PIN PA22 TCC0 (channel 0)
SCL_PIN PA23 TCC0 (channel 1)
SPI0_SCK_PIN PB11 TCC0 (channel 1)
SPI0_SDO_PIN PB10 TCC0 (channel 0)
SPI0_SDI_PIN PA12 TCC2 (channel 0), TCC0 (channel 2)

Machine Package Docs

Documentation for the machine package for the Adafruit Feather M0

Flashing

UF2

The Feather M0 comes with the UF2 bootloader already installed.

CLI Flashing

  • Plug your Feather M0 into your computer’s USB port.

  • Flash your TinyGo program to the board using this command:

    tinygo flash -target=feather-m0 [PATH TO YOUR PROGRAM]
    
  • The Feather M0 board should restart and then begin running your program.

Troubleshooting

If you have troubles getting your Feather M0 board to receive code, try this:

  • Press the “RESET” button on the board two times to get the Feather M0 board ready to receive code.
  • The Feather M0 board will appear to your computer like a USB drive.
  • Now try running the command as above:
tinygo flash -target=feather-m0 [PATH TO YOUR PROGRAM]

Once you have updated your Feather M0 board the first time, after that you should be able to flash it entirely from the command line.

Notes

You can use the USB port to the Feather M0 as a serial port. UART0 refers to this connection.