STM32 Nucleo WL55JC
The STM32 Nucleo WL55JC is an ARM development board based on the ST Micro STM32WL55JCI SoC.
It has onboard LoRa®, (G)FSK, (G)MSK, and BPSK as well as 3 user LEDs, 3 user buttons and 1 reset push-button
Interfaces
| Interface | Hardware Supported | TinyGo Support |
|---|---|---|
| GPIO | YES | YES |
| UART | YES | YES |
| SPI | YES | YES |
| I2C | YES | YES |
| ADC | YES | Not yet |
| PWM | YES | Not yet |
| USBDevice | NO | NO |
Pins
| Pin | Hardware pin | Alternative names |
|---|---|---|
LED_BLUE |
PB15 |
|
LED_GREEN |
PB9 |
|
LED_RED |
PB11 |
LED |
BTN1 |
PA0 |
BUTTON |
BTN2 |
PA1 |
|
BTN3 |
PC6 |
|
SPI0_NSS_PIN |
PA4 |
|
SPI0_SCK_PIN |
PA5 |
|
SPI0_SDO_PIN |
PA6 |
|
SPI0_SDI_PIN |
PA7 |
|
UART1_TX_PIN |
PB6 |
|
UART1_RX_PIN |
PB7 |
|
UART2_RX_PIN |
PA3 |
UART_RX_PIN |
UART2_TX_PIN |
PA2 |
UART_TX_PIN |
I2C1_SCL_PIN |
PA9 |
I2C0_SCL_PIN |
I2C1_SDA_PIN |
PA10 |
I2C0_SDA_PIN |
I2C2_SCL_PIN |
PA12 |
|
I2C2_SDA_PIN |
PA11 |
Machine Package Docs
Documentation for the machine package for the STM32 Nucleo WL55JC
Flashing
OpenOCD
Programs are loaded onto the STM32 Nucleo WL55JC with the onboard STLink hardware programmer, using the openocd command line utility program to perform the board flashing. You must install OpenOCD before you will be able to flash the STM32 Nucleo WL55JC board with your TinyGo code.
- Plug your STM32 Nucleo WL55JC into your computer’s USB port.
- Build and flash your TinyGo program using
tinygo flash -target=nucleo-wl55jc
Last modified June 28, 2022: microcontrollers: auto-generate a list of available pins (0710c6d)